Set Rite Toilet Flange Extender - Step one: Get the Resources You'll Need Prepare the region to the new bathroom by cleansing the flange in which the wax ring was. Clean the bottom of the debris and fasten any loose flooring.
Place your brand-new bathroom products within the slots provided on the bottom flange. Tip the brand new Set Rite Toilet Flange Extender bowl on its
side and lightly press the brand new wax ring to allow it to adhere in the bathroom bowl.
To take out stained bowl start by using the
razor knife to slice off any caulk that's round the bowl.
Removing the caulk will assure you don't damage the flooring when
pulling stained bowl as well as could make it easier for doing that.
Be careful not to over tighten to avoid breaking up the porcelain. The model and label of Set Rite Toilet Flange Extenderis determined by your taste and budget.
You'll have to understand the clearance you have; as
many bathrooms have different size tanks. You may choose to pick-up a tube of silicone caulk too.Now take both bathroom off
They are situated underneath the caps on them of stained base. In some cases these bolts may be rusted into the nuts and won't break loose.
If that's something you encounter then utilize a small hacksaw blade to slice the bolt below the nut.
First disconnect the river supply on the bathroom by turning from the closed valve located at the back with the bathroom around the wall.
Now flush stained repeatedly to take out just as much water out with the bowl as you can. Remove the lid of stained tank and open
the flapper valve to drain just as much water out with the tank as you can and flush.
Now connect the production line back in the
underneath with the bathroom. Open the distribution line disconnect valve gradually and permit stained tank fill.
Check for leaks all round the bathroom as you accomplish that. When the tank is full, flush stained to ensure the wax ring sealed correctly.
Set Rite Toilet Flange Extender
Measure Two: Materials
Step Four: Fixing the bathroomNow carefully direct the bathroom bowl across the products in as direct down
movement as you can. Be careful not to damage the wax ring when you guide stained bowl in place.
Now rock the bathroom from
side to side to create the wax ring in place and push the bathroom bowl all the way down to satisfy the floor.
Now place the nuts on
the products fostering not to over tighten as it's possible to compromise the porcelain effortlessly.
Step Three: Removing the
Old Set Rite Toilet Flange ExtenderYou must not find any water originating from underneath the bowl. If you do maybe you have damaged the wax ring when placing
on the bowl or didn't place it properly.
If things are functioning correctly all that you should do is caulk around stained
bowl, then squeeze tank lid and also the mounting bolt covers on the bowl.
Obey the directions given by producer on the seals
to use relating to the tank and bowl. Guide the tank across the mounting holes and set on the tank.
Now run the products with
any washers that producer has included over the tank and place the nuts around the bottom. Tighten the nuts attentively,
getting them cozy and not too tight.
Step Five: Mounting the Toilet TankNow it's possible to take out the bathroom by gently rocking it back and forth, to interrupt the seal how the wax ring has left.
When the bathroom is free of charge only pull-up and out.Next you will
need to disconnect the river supply line. Utilize a standard wrench or adjustable wrench.
If you're taking out the whole Set Rite Toilet Flange Extender then
you will not need to take the tank from the bathroom bowl if you don't desire to for convenience of working on the project. To substitute a bathroom you will need only a couple of tools. You'll also have to have a blade and some towels for cleanup.
If you're removing
the tank, than do so by subtracting from the nuts the tank bolts situated under and back of stained tank. If the nuts turn the bolt you might have to have a screw driver to the bolt internally while turning the nut from below to split them free.